Das Erweiterungsmodul für zusammengesetzte Oben-Unten-Messungen

The extension module for composite top-down measurements

Of course, valuable knowledge on the dimensional stability of a component, e.g. thickness, angle or radii and their relation, can be gained by checking the upper and lower contour. But so far, the problem was that both contours had to be analysed in two different measurement runs and subsequently, had to be more or less correlated. Using optacom top down, this task will be fixed comfortably and precisely to your entire satisfaction – that you are used to at optacom.

Given that contour measurements obtained through our machines stand in precise dimensional relation with each other based on absolute coordinates from the very beginning, you can use optacom topdown to combine two (or more) sub-measurements in a straightforward and automatic fashion.